Signature Kitchen Builders

Signature Kitchen Builders <![CDATA[Step Four: After visiting the Edgebander the next stop in the process is a stop at the Sliding Table Saw. This stop is mainly for smaller jobs. ]]> <![CDATA[Step Three: The second stop in the cabinet making process is at the Edgebander. The Edgebander applies a finished edge to the cuts to seal any raw edges. ]]> <![CDATA[Step Two: The first stop in the cabinet making process is a visit to the Beam Saw. The Beam Saw will cut out multiple sheets of wood at the same time to ensure your cabinet is built to your desired specifications.]]> <![CDATA[Step One: The materials enter the factory and are now ready to be turned into cabinets]]> <![CDATA[Step Five: Once all of the cuts are made it is time to visit the Drawer Assembly Line. This is where we make sure that all of our cuts fit together according to your specifications. ]]> <![CDATA[Step Eleven: The last step in our process is to get your cabinetry ready to be shipped in our Shipping Department. Enjoy your new Signature Kitchen Builders Inc. Cabinetry! ]]> <![CDATA[Step Ten: Now that your cabinetry has been cut and finished, it is now time to put it all together in the Assembly Department. We make sure everything fits together before we send it out. ]]> <![CDATA[Step Nine: The last step in the Finishing Department is a visit to the drying room. This is a sealed off area that allows your cabinetry to dry without any distractions that may cause imperfections in the stain. ]]> <![CDATA[Step Eight: The next step in the Finishing Department is the spraying area. This stop is where your cabinet receives its colour and shine. ]]> <![CDATA[Step Seven: The next few stages are to give your cabinetry a finish, polish and final touch up. The first stop in the Finishing Department is the sanding area. Every surface of your cabinet is sanded down so it is smooth to the touch. ]]>